Intro:

Your Decal Will Arrive With Three Layers: 

• The top layer is Transfer tape, which holds the letters/image in place for easy installation. 
• The middle layer is the Die-Cut Decal. 
• The bottom layer is the wax paper backing.

Instructions:

Step 1. Place the decal on a flat, clean surface so the the wax backing is facing you. Run a squeegee over the wax backing firmly twice, and repeat with the other side of the decal.

Step 2. Choose the location you are going to apply the vinyl decal. (The location you choose cannot be located on an area which does not contain a flat even surface. This is done to maintain proper adhesion to the surface).

Step 3. Clean area with soapy solution the area in which the vinyl decal will be installed. (Make sure there are no dirt, dust, oil or other substances which might cause the decal to not adhere properly). 

Step 4. (Optional*) Clean the area with alcohol prep pad in order to get the best adhesion possible and to maintain longevity of the vinyl decal. 

Step 5. (Optional*) Use tape in order to best place the vinyl decal. To apply tape properly place the decal to the area in which you are planning on placing the vinyl decal. Once in the location; apply the tape to the surface and the transfer tape. Continue to next step.

Step 6. remove wax backing from the decal leaving; the transfer tape and the decal together. (Make sure to take your time in doing so, if the decal has not been squeegee'd properly, lettering may stay on the wax surface causing an incomplete decal).

Step 7. place the decal on the desired surface, vinyl side facing the surface and transfer tape facing you. (Make sure it is aligned properly).

Step 8. Squeegee over the transfer tape and vinyl decal for best results do this multiple times over. 

Step 9. Remove the transfer tape from the decal at a 45 degree plus angle. (For best results use squeegee on the lifting edge of the transfer tape while pulling the decal back maintaining constant pressure). 

Step 10. Enjoy your new Vinyl Decal

Video Link: